Working Above the Ceiling
1. Route a Cat-5e (or better) cable from the ceiling box to the mixer or other audio device. The cable may be up to
100 ft. (30 m.) long.
2. Thread the cable through the opening in the side of the ceiling box.
3. Install the split grommet in the opening in the side of the ceiling box to keep the cable from chafing.
4. Connect the cable to the port labeled OUT TO MIXER.
5. Reinstall the cover on the ceiling box.
6. Thread the drop cable through the opening in the ceiling and place the ceiling box flat.
Working Below the Ceiling
1. Connect the drop cable to the port in the microphone body.
2. Fit the strain relief boot over the drop cable.
3. Fit the strain relief boot into place in the microphone body.
4. Slide both the slotted trim plates over the cable, making sure the countersinks face outward, and turn them so
the slots are on opposite sides. Use the 3/4 inch flat head screws to secure the trim plates to the threaded posts
on the bottom of the interface box.
(Illustration shaded for clarity)
Contact Vaddio Technical Support if you have questions or encounter any problems. Phone 800.572.2011 /
+1.763.971.4400, email
Installing CeilingMIC Conference Room Microphones
5
