REVEAL IN-Wall Cameras
REVEAL IN-Wall Camera Manual Document Number 342-0059 Rev. A
Page 9 of 28
Step 8:
Insert the four (4) #8-32 x 1.25” sheet metal screws into the previously installed spiral wall anchors but do not tighten
completely. Use the level and adjust the enclosure so that the system is both level and plumb, then tighten the screws.
Step 9:
Apply the ½” OD x ¼” ID x 0.125” white nylon spacers over the ¼-20 PEM posts attached to the enclosure’s mounting
flanges.
STEP 10:
To install the Face Frame Cover, first connect the 4-Wire IR/LED lead with the white connector to the camera control
board and connect the 2-Wire Smart Glass lead with the black connector to the control board as shown.
#8-32 x 1.25” Sheet
Metal Screws X 4
Trusty & Accurate Level
¼”-20 Post
Mounting
Flange
½” OD x ¼” ID x 1/8”
White Nylon Spacer X 4
4-Wire White Connector
4-Wire
2-Wire
2-Wire Black
Connector
Rear of Face
Frame Cover
