The pump is designed to be used with clean water
in a residential application. Do not use it with
alternative fluids, specifically abrasive, corrosive
or explosive fluids. Do not install or operate your
pump in an explosive environment or near
combustible matter. Do not pump hydrocarbons
with this pump.
Incorrectly installed or tested equipment may fail,
causing severe injury or property damage.
To avoid burns when handling the motor, let it cool
for at least 20 minutes before trying to work on it.
A thermal overload switch protects the motor from
heat damage during operation.
If the supply cord is damaged, it must be replaced
by the manufacturer, it’s service agent or similarly
qualified persons in order to avoid a hazard
Children should be supervised to ensure they do
not play with the appliance
The pump must be supplied through a residual cur-
rent device (RCD) having a rated residual operating
current not exceeding 30mA.
Only qualified, licensed personnel should install
pump. The electrical installation shall be in
accordance with the national wiring rules (AS/NZS
3000)
The pump operator must be provided with this
manual. This must be read before and during opera-
tion.
These instructions are a guide only. Users not
familiar with pumping equipment should seek
advice from people experienced in pump equipment
and installation.
Single-phase motors are provided with built-in
thermal overload protection. Motors must connect
the earth wire before use.
The pump is electrically connected. Ensure that it
is isolated from electrical supply during installation
and any subsequent service work.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance
by a person responsible for their safety.
CONSTRUCTION
Pump Head Body
Celcon GC25 POM
Motor Body
Cast Alloy
Impeller
Celcon GC25 POM
Impeller Shaft
Alumina Ceramic
Thrust Rings
Alumina Ceramic
Bearings
PTFE
O-Ring Seals
EPDM
APPLICATIONS
The V30-RC is an ‘on-demand’ recirculating pump. The pump
reduces water wastage by returning cold water to the hot water unit
while waiting for hot water to come through the tap.
USAGE LIMITATIONS
•
Type of liquid: clean water with no suspended abrasive material
•
Maximum liquid temperature: 60
O
C
•
Maximum total head: 8m
•
Maximum flowrate: 15 l/min
VADA - V30-RC
WARNINGS
Please pay careful attention to the following warnings signs and indications.