FIRST TIME USE
1
Make sure the PP101 Protector Plate is in place. This
is necessary for proper suction.
Upon receiving your vacuum system, lift off the lid.
The protector plate should be located inside the can
just below the HEPA bag.
The protector plate is installed correctly when it lays
flat, prong side down, directly under the HEPA bag.
The warning label should be facing up. The plate
provides a barrier between the HEPA bag and mesh
screen. This allows air to circulate preventing the mo-
tor from overheating.
Do not throw this part away.
PP101
Protector Plate
Protector plate must be
installed properly for the
vacuum to work
Before
using your system for the first time, follow these 3 steps.
2
Install the HEPA bag onto the inlet inside the canister.
First, take the bag and fully expand it.
Then place it in the canister and slide its gasket onto the
inlet stem until it drops into place in the ridge that is
around the inlet stem.
Replace the lid onto the dirt canister and ensure that it
seals properly.
3
You will need to attach the curved wand to the hose.
To do so, you will twist the wand to the
LEFT
as you
thread it onto the hose. Note: This is the opposite direc-
tion of typical threading.
REMINDER: This is not a wet pickup and cannot be used with liquid.
Doing so will void warranty.
