Vaco Hiti380, Руководство пользователя

Страница: 7 / 64

GENERAL SAFETY INSTRUCTIONS
1. Before using the machine, carefully read this entire user manual.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. Do not use the heater until it has been fully installed in accordance with the
instructions under the heading ‘Installation’.
4. This heater is strictly intended for normal domestic use. Only use it for the (additional)
heating of your home.
5. This heater (with IP24 protection) is suitable for use in wet or damp rooms such as
bathrooms, washrooms, etc., and is intended for indoor use only! If you use the heater
in bathroom or washroom (wet or damp room), please make sure the IPX0 plug
cannot be used in Zone 0 (IPX7), Zone 1(IPX4) and Zone 2(IPX4) according to HD
60364-7-701: 2007 unless the plug and the socket outlet are protected by an
enclosure with at least IPX4 protection degree. Keep the heater at least 60 cm. away
from water points and make sure that it can never fall into water and that no water can
enter the stove. Should this ever happen, take out the plug from the socket first! Do
not use an internally wet stove again but offer it for repair. Never immerse the heater,
cord or plug in water or other liquids and never touch the heater with wet hands.
6. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. Only use an undamaged, earthed socket that is
secured with a 30 mA
earth leakage circuit breaker . The electrical socket that you
are using must be to hand at all times in order to be able to remove the plug from the
socket in the event of an emergency
7. Fully extend the cord before plugging in the heater. Make sure it does not come into
contact with any part of the heater and prevent it from heating up any other way. Do
not run the cord underneath carpeting; do not cover it with mats, carpet strips or
similar and make sure it is not placed in any passageways. Make sure the cord cannot
be stepped on and that no furniture is placed on top of it. Do not lead the cord
around sharp corners and do not roll it up too tightly after use!
8. If possible, do not use an extension cord, as this poses the risk of overheating and fire.
If the use of an extension cord is unavoidable, then make sure it is an undamaged,
approved extension cord with a minimum diameter of 2 x 1.5 mm² and a minimum
permissible power of 1000 Watt. To prevent overheating, always fully extend the cord!