Vacmaster VOC507S, Руководство оператора

Страница: 7 / 51

7
GENERAL ASSEMBLY INSTRUCTIONS
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four casters into the sockets on the bottom
of the base. Press casters down until they snap into place (Fig. 5).
6. Insert the handle into the slots located on the top of the power head and secure it with the
screws provided. Do not over-tighten screws (Fig. 6).
7. Your vacuum comes ready for dry vacuum cleaning. If the reusable cloth filter is not installed,
refer to page 13 for installation instructions (Fig. 7 & 8).
8. For wet vacuum cleaning, remove the reusable cloth filter, and install the supplied foam wet
filter. See page 13 for the foam wet filter installation instructions (Fig. 9).
9. Place the power head back on the collection tank and secure into place using the latches
(Fig. 10).
10.Insert the locking end of the hose into the vacuum port on the collection tank and lock into
place (Fig. 11).
11.Choose the desired attachment and insert onto the end of the hose or extension wand (Fig.12).
11 12
6 7 5
4 1
10
9
8
2 3
1
2
A Philips head screwdriver is required.
WARNING:
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY
VACUUM. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.