Vacmaster VMVDK1538SWC-06, Оригинальное руководство пользователя

Страница: 11 / 24

11
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Attach the carry handle into the slots located on the top of the power head. Secure them with
supplied screws (Fig. 1).
3. Turn the container upside down and insert the front feet with casters into the slots and apply
pressure until they click into place (Fig. 2).
4. Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on
the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same
steps on the other end of the axle (Fig. 3).
5. To position the hose storage rack, insert one end into the channel on the side of the power
head, making sure it is secured in place. Apply inward pressure to the other side and insert it
into the opposite channel (Fig. 4).
6. Unfold the upper handle assembly into the upright position. The upper handle has two
adjustable height positions. Secure in place by tightening the wig knobs clockwise (Fig. 5).
7. Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
If the cartridge filter is not installed, refer to page 13.
8. To maintain M-class certification this vacuum cleaner must be used with a disposable collection
means. By removing the dust bag and disposable bag when collecting debris the user runs the
risk of voiding vacuum cleaner certification.
1) To use a dust bag, fully fit the dust bag flange onto the inlet stub (Fig. 6).
2) To use a disposable bag, place the disposable bag into the container, and fully fit the
disposable bag flange onto the inlet stub. Fold the top edge of the disposable bag over the
rim of the container (Fig. 7).
3) To use a disposable bag and a dust bag together, place the disposable bag into the
container and fully fit the disposable bag flange onto the inlet stub, and fold the top edge of
the disposable bag over the rim of the container, then fully fit the dust bag flange onto the
inlet stub (Fig. 8).
9. For wet vacuum cleaning, replace the cartridge filter with the foam filter supplied. Do not use a
dust bag and/or a disposable bag when wet vacuuming. If the foam filter is not installed, refer to
page 14.
10. Secure the power head back on the container using the latches. Insert the locking end of the
hose into the suction port of the container and turn clockwise to lock into place (Fig. 9).
11. Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
Floor Nozzle Attachments
The floor nozzle comes supplied with additional attachments to ensure correct suction across
different floor surfaces and applications.
1) To remove the floor nozzle attachments, turn the floor tool holder upside down.
2) Using a flathead screwdriver or other suitable tool, locate the holding clips on each outer edge.
Insert a flat edged object directly next to the holding clip, between the insert and the floor tool