Vacmaster VK809PIWR, Руководство оператора

Страница: 15 / 23

15
NOTE: Once depleted, the cleaning solution can be replaced by a high quality liquid carpet
cleaning solution that can be purchased from a local retailer. Always use the cleaning solution as
directed by the manufacturer.
5. Insert the cleaning solution tank back into the vacuum base. Connect the cleaning solution tube
to the cleaning solution inlet coupling on the rear side of the power head. Insert the other end of
the solution tube to the cleaning solution tank and secure the cap into place (Fig. 4).
6. Insert the locking end of the hose into the vacuum port of the collection tank and turn clockwise
to lock into place. Insert the threaded connector on the end of the cleaning solution delivery tube
into the cleaning solution outlet coupling (Fig. 5).
7. Ensure the hose and delivery tube are locked into the remote control handle (Fig. 6). The air
flow regulation on the remote control handle allows you to manually change the amount of
vacuum suction.
8. Attach the long delivery tube by installing the spray head to the bottom of the carpet shampoo
nozzle and make sure it is locked into place (Fig. 7).
9. Push the end of the remote control handle into the telescopic wand. Attach the carpet shampoo
nozzle to the telescopic wand. Connect the other end of the long delivery tube to the remote
control handle. This telescopic wand is equipped with a delivery tube hook. The long delivery
tube can be attached to the hook for convenient use (Fig. 8).
10.To clean sofas, chairs, stairs and car interiors, connect the hand held shampoo nozzle with the
short delivery tube (Fig. 9).
NOTE: When cleaning the headliner of your car, rotate the air flow regulation counter-clockwise to
decrease the suction power if the suction power is high.
11.Plug the power cord into a power outlet (Fig. 10).
12.Turn on the motor by flipping the switch to the “I” ON position. Press the detergent mode
button, indicated by the following symbol , on either the remote control handle or the power
head for cleaning solution application only. Select both the detergent mode and vacuum mode
for simultaneous shampoo and wet vacuum operation (Fig. 11).
13.Once you have completed cleaning, switch off the vacuum by pressing detergent mode button
on either the remote control handle or the power head. Switch to the “O” OFF position, unplug
the power cord from the power outlet and drain the liquid (Fig. 12).
O = OFF I = ON = DETERGENT MODE
NOTE: VACUUM THE CARPET/UPHOLSTERY THOROUGHLY BEFORE USING THE
SHAMPOO MODE.
• For carpet cleaning it is recommended to remove all furniture from the room to be cleaned, or
move it away from the cleaning area. Clean the whole carpet systematically in squares, using
strokes of approximately 5ft. (1.5m) each. This avoids walking over the cleaned carpet until it is
completely dry.
• Start furthest away from the entrance of the room, extend the hose and work backwards.
• Pull the carpet shampoo nozzle back towards you in approximately 5ft. strokes. Refill the
cleaning solution tank if the solution runs out.
• Select the vacuum mode, indicated by the following symbol , to suck up the dirty solution.
More cleaning solution can be applied to heavily soiled areas. The dirty liquid is visible as it is
sucked up through the carpet shampoo nozzle. Stop vacuuming when the liquid being extracted
is no longer dirty.
• Do not walk over or place furniture on the cleaned area until it is completely dry.
WARNING: THE MOTOR NOISE CHANGES TO A HIGHER PITCH WHEN THE
COLLECTION TANK IS FULL OR BLOCKED. STOP THE VACUUM IMMEDIATELY AND EMPTY
THE COLLECTION TANK.