1
6
7
1
5
2
4
ON
OFF
3
2
3
4
5
1
6
9
M
AINTENANCE
I
NSTALLING HEPA FILTER AND PRE-FILTER
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER SOCKET
BEFORE REMOVING THE POWER HEAD FROM THE CONTAINER.
1. Verify that the power cord is disconnected from the power socket. (fig. 1)
2. Disconnect the hose from the vacuum cleaner. (fig. 2)
3. Verify cap is attached to inlet port with chain.
4. Fit cap to inlet port to seal it for transportation if necessary (fig. 4)
5. Undo the latches and remove the power head from the container. (fig. 5)
6. Clear all dirt or debris from the container and hose. (fig. 6)
7. Clean the foam filter by washing it with water and mild soap. (fig. 7)
8. Check the hose, attachments, and power cord to verify that they have not been damaged.
Installing HEPA Filter And Pre-filter
1. Verify that the power cord is disconnected from the power socket. (fig. 1)
2. Remove power head and place in an upside down position.
3. Install the HEPA filter over the filter cage with the flat end of the filter towards the
vacuum cleaner power head. Carefully push filter in until it stops against the power head.
(fig. 2 )
4. Place filter retainer on top of cartridge filter over the raise lip and tighten down by
turning retainer Clockwise, do not over tighten. (fig. 3)
5. Slide the pre-filter onto the assembled HEPA filter, over the lower end cap. Tighten
the band clamp on the pre-filter with a screwdriver to ensure proper installation.(fig. 4 & 5)
Removing HEPA Filter And Pre-filter
1. Loosen the band clamp on the pre-filter with a screwdriver, and remove the pre-filter
from the HEPA filter.
2. Unlock and remove the filter retainer by tuning retainer counter clockwise.
3. Carefully hold and pull the HEPA filter up for removal. (fig. 6)
4. Re-install the HEPA filter into place as instructed above in steps 2 and 3 of Installing
HEPA filter.
6. Wet filter should be removed and allowed to air dry for 24 hours before installing
onto the filter cage.
IMPORTANT!
Change the cartridge filter regularly for best performance. ALWAYS
USE THE HEPA FILTER FOR DRY VACUUMING. If the machine is used for dry vacuuming
without the HEPA filter and retainer attached, the motor will burn out and the warranty
will be voided.
NOTICE!
The HEPA cartridge filter included is made of high quality materials designed
to stop small dust particles. The HEPA cartridge filter should be used for dry pick-up only.
A dry HEPA cartridge filter is necessary to pick up dust. If the HEPA cartridge filter is wet,
it will clog quickly and be very difficult to clean. Handle the HEPA cartridge filter carefully
when removing it for replacing it. Check the HEPA cartridge filter for tears or small holes,
a small hole can let dust pass through and out of the cleaner.
Do not use a HEPA cartridge filter with holes or tears, replace it immediately.
