Vacmaster VJE1650SW, Инструкция по эксплуатации

Страница: 11 / 32

11
GB GB
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Turn the container upside down. Insert the two front feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 1).
3) Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on
the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same
steps on the other end of the axle (Fig. 2).
4) To position the hose storage rack, insert one side of the rack into the channel marked on the
side ventilation opening, making sure it is secured in place. Stretch the other end outwards
and insert it into the corresponding channel (Fig. 3).
5) Insert the push handle into the mounting brackets on the tank body. Push down until the
locking pins click in place (Fig. 4).
6) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter and pre-
filter pre-installed. If the cartridge filter and pre-filter are not installed, refer to page 12.
7) Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 5).
8) For wet vacuum cleaning, replace the cartridge filter and pre-filter with the foam filter supplied.
Do not use a dust bag when wet vacuuming. If the foam filter is not installed, refer to page 12.
9) Secure the power head back on the container, using the 2 side latches. Insert the locking end
of the hose into the suction port of the container and turn clockwise to lock into place (Fig. 6).
10) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle (Fig.
7). To use the dusting brush and crevice tool with an extension wand you will be required to use
the metal accessory adaptor.
1. Switching ON/OFF
Connect the mains plug to a suitable a power outlet.
OPERATION
Position Status
I on
O off
WARNING:
ENSURE YOU READ, UNDERSTAND AND APPLY SECTION
ENTITLED ‘SAFETY INFORMATION’.
2. Dry & Wet Vacuum Operation