Cord Rewind Button
Vacuum Port
Handle
Rear Wheel
Tool Caddy
Latch
Power Switch
Casters
Power Head
Container
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
G
ENERAL ASSEMBLY iNStRUCtiONS
WARNiNG:
Do noT plUg In poWEr CorD To poWEr oUTlET, maKE SUrE
plUg IS DISConnECTED BEforE aSSEmBlIng THE WET/Dry VaC
UnpaCKIng yoUr WET/Dry VaCUUm & gEnEral aSSEmBly
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig. 1)
2. Undo the latches. (fig. 2)
3. Lift the power head off the container. (fig. 3)
4. Remove the contents from inside the container, make sure you have all contents as
listed on page 5. (fig. 4)
5. Turn the container upside down and insert the two casters (2) into the slots on
the front side of the container. Apply downward pressure until the casters snap
into place. (fig. 5)
6. Slide the rear wheels into the slots making sure to match the wheel number to the
corresponding number on the wheel slot and use screws to secure them. Do not
over tighten the screw. (fig. 6 & 7)
7. Your vacuum comes ready for dry vacuum cleaning. If cartridge filter is not
installed refer to page 9 for filter installation. (fig. 8 & 9)
8. For wet vacuum cleaning, install the supplied foam filter. (fig. 10) See page 10 for
filter installation.
9. Place the power head back on the container, aligning the top section with the
latches, and lock into place. (fig. 11)
10.Insert the handle into the slots located on the top of the power head and secure
it with the screws provided. Do not over tighten the screw. (fig. 12)
11. Hang the tool caddy to the hooks on the rear of the vacuum. (fig. 13)
12. Secure the large end of the hose onto the vacuum port on the container and
screw into place. (fig. 14)
13. Choose the desired accessories and extension wands and push onto the hose.
(fig. 15)
pOLARiZED pLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one with the
blade wider than the other). This plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not change the plug in any way.
