Vacmaster VDK1430SFC, Оригинальное руководство пользователя

Страница: 11 / 24

11
GB
OPERATION
1. Switching On/Off
Connect the mains plug to a suitable power outlet.
Position Status
I on
O off
II automatic synchronized start-up
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3. Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place. Secure them with supplied screws (Fig. 2).
4. To position the hose storage rack, insert one end into the channel on the side of the power
head, making sure it is secured in place. Apply inward pressure to the other side and insert it
into the opposite channel (Fig. 3).
5. Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed.
If the cartridge filter is not installed, refer to page 12.
6. Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 4).
7. For wet vacuum cleaning, replace the cartridge filter with the foam filter supplied. Do not use a
dust bag when wet vacuuming. If the foam filter is not installed, refer to page 13.
8. Secure the power head back on the container using the latches. Insert the locking end of the
hose into the suction port of the container. Ensure the push clip is securely positioned (Fig. 5).
9. Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.
Floor Nozzle Attachments
The floor nozzle comes supplied with additional attachments to ensure correct suction across
different floor surfaces and applications.
1) To remove the floor nozzle attachments, turn the floor tool holder upside down.
2) Using a flathead screwdriver or other suitable tool, locate the holding clips on each outer edge.
Insert a flat edged object directly next to the holding clip, between the insert and the floor tool
holder. Pry the attachment up from underneath (Fig. 6 & 7).
3) Insert the new attachments into the holder applying downwards pressure (Fig. 7).
4) The attachments can be used in three combinations (Fig. 8):
Brush and Squeegee Combination: For use with mixture of wet or dry liquids.
Dual Brush Combination: For use with dry materials or carpeted floor surfaces.
Dual Squeegee Combination: For use on hard floor with wet liquids
Note: The textured side of the rubber squeegee must be facing outwards.