Vacmaster VBV1210, Руководство оператора

Страница: 13 / 52

13
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the four screws holding the intake shield and lift off the shield (Fig. 2).
3. Remove the foam pad from the blower and clean the foam pad with soapy water and allow to
dry (Fig. 3).
4. Check the foam pad for reuse. If you need to replace the foam pad consult the parts list of the
manual.
5. Replace the foam pad onto the blower aligning the holes to the screw tabs (Fig. 4).
6. Reinstall the intake shield and the four screws (Fig. 5).
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories
should be cleaned and stored so they can be readily available when needed. Store the wet/dry
vacuum indoors.
REPAIRS
5HSDLUVIRUWKLVZHWGU\YDFXXPVKRXOGEHSHUIRUPHGRQO\E\TXDOL¿HGVHUYLFHSHUVRQQHOXVLQJ
only identical replacement parts.
INSTALLING CARTRIDGE FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the powerhead and place in an upside-down position.
,QVWDOOWKHFDUWULGJH¿OWHURYHUWKH¿OWHUFDJHPDNLQJVXUHWKHFDJHLVFRPSOHWHO\FRYHUHG
(Fig. 2 & 3).
3ODFHWKH¿OWHUUHWDLQHURQWKHWRSRIWKHFDUWULGJH¿OWHURYHUWKHUDLVHGOLSDQGWLJKWHQGRZQE\
turning the retainer clockwise; do not over-tighten (Fig. 4 & 5).
5. Place the powerhead back onto the collection tank.
REMOVING & CLEANING CARTRIDGE FILTER
8QORFNDQGUHPRYHWKH¿OWHUUHWDLQHUE\WXUQLQJWKHUHWDLQHUKDQGOHFRXQWHUFORFNZLVH
:LWKWKHUHPRYHGSRZHUKHDGLQDQXSVLGHGRZQSRVLWLRQFDUHIXOO\UHPRYHWKHFDUWULGJH¿OWHU
IURPWKH¿OWHUFDJH)LJ
&OHDQWKHFDUWULGJH¿OWHUE\JHQWO\WDSSLQJRUEUXVKLQJGLUWRII&OHDQLQJVKRXOGQRWEHGRQH
LQGRRUVLQOLYLQJDUHDV)RURSWLPDOSHUIRUPDQFHDQHZ¿OWHULVUHFRPPHQGHG
,QVWDOOFOHDQHGRUQHZ¿OWHUDVDERYHLQVWHSVRI,QVWDOOLQJ&DUWULGJH)LOWHU
:HW¿OWHUVVKRXOGEHUHPRYHGDQGDOORZHGWRDLUGU\IRUKRXUVEHIRUHLQVWDOOLQJRQWRWKH¿OWHU
cage.
INSTALLING & CLEANING CARTRIDGE FILTER
6
5 4
2
3
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
BEFORE REMOVING THE POWERHEAD FROM THE COLLECTION TANK.