8
M
AINTENANCE
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE
PLUG IS DISCONNECTED BEFORE CHANGING AND CLEANING FILTERS.
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
2. Disconnect the hose from the vacuum, turning large end in counter clockwise
direction. (fi g.2)
3. Undo the latches and remove the power head from the container. (fi g.3)
4. Clear all dirt or debris from the container and hose. (fi g.4)
5. Check the hose, attachments, and power cord to verify that they have not been
damaged.
IMPORTANT!
Clean or change the cartridge fi lter regularly for best
performance. ALWAYS USE CARTRIDGE FILTER FOR DRY VACUUMING. If the
machine is used with out the cartridge fi lter, the motor will burn out and the
warranty will be voided. Always keep spare fi lters on-hand.
NOTICE!
The fi lters included are made of high quality materials designed to
stop small dust particles. The cartridge fi lter should be used for dry pick-up
only. A dry cartridge fi lter is necessary to pick up dust. If the cartridge fi lter
is wet, it will clog quickly and be very diffi cult to clean. Handle the fi lter
carefully when removing it for cleaning and replacing it. Check the fi lters for
tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a fi lter with holes or tears, replace it immediately.
WARNING!
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE
REMOVING THE POWER HEAD FROM CONTAINER.
1
3
2
4
I
NSTALLING & CLEANING CARTRIDGE FILTERS
Installing Cartridge Filter
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
2. Remove power head and place in upside down position.
3. Slide the cartridge fi lter down over the fi lter cage and carefully push fi lter in until it
stops against the power head. (fig.2)
4. Place fi lter retainer on top of cartridge fi lter and tighten down by turning retainer
handle clockwise. (fi g.3 & 4)
Removing and Cleaning Cartridge Filter
1. Unlock and remove the fi lter retainer by tuning retainer handle counter clockwise.
2. Carefully hold and pull the cartridge fi lter up for removal. (fig.5)
3. Clean the cartridge fi lter by gently tapping or brushing dirt off. Cleaning should
not be done indoors in living areas. For optimal performance a new fi lter is
recommended.
4. Install cleaned or new fi lter into place as instructed above in steps 2 and 3 of
installing Cartridge Filter.
5. Wet fi lters should be removed and allowed to air dry for 24 hours before installing
onto the fi lter cage.
1
2
4
3
5
I
NSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
1. Remove power head and place in upside down position. Follow instructions to
remove cartridge fi lter.
2. Carefully slide foam sleeve fi lter down over the fi lter cage making sure the whole
cage is covered.(fig.2)
3. Replace the power head on to the container.
