5
H
I
G
F
E
C
D
B
A
M
N
L
P
S
R
Q
O
J
K
G
ENERAL ASSEMBLY INSTRUCTIONS
WARNING:
DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY.
1. Verify that the power cord is disconnected from the outlet.(fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the container. (fig.3)
3. Remove the contents from inside the container, make sure you have all contents as
listed on page12. (fig.4)
4. With the power head removed, turn the container upside down. Insert the two
casters into the socket on to bottom of the castor feet. (fig.5)
5. Insert the rear wheel shaft (R) into the rear support block. Insert washer (P) on
the shaft, then insert rear wheel (M) on the shaft. Insert the ‘R’ lock pin (O) into the
hole on the end of the shaft to lock the wheel. Snap the hub cap (N) on to the
wheel. Repeat the same steps at the other end of the shaft. Please notice you must
install the hub cap on to the wheel , otherwise the ‘R’ lock pin will come loose
result in wheel do not work .(fig. 6)
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 9 for
filter installation.
7. Your vacuum comes ready for dry vacuum cleaning with PET cartridge filter pre-
installed. If cartridge filter is not installed, refer to page 8 for filter installation.
(fig.8&fig.9)The PET cartridge filter fit for wet & dry vacuum cleaning.
8. Put the PRE cloth filter over the filter tray with the attached PET cartridge filter.
(fig.10)
9. Optional, for improved dust filtering, fit collection bag flange onto the inlet stub,
taking care not to damage the bag. (fig.11)
10. Place the power head back on the container, and secure into place using the 2
side latches. (fig.12&fig.13)
11. Store accessories on accessory storage frame or posts back of this vac.
(fig.14)
12. Secure the large end of the hose into the vacuum port on the container and screw
into place. (fig.15)
13. Choose the desired accessories and extension wands and push onto the suction
tube. (fig.16)
7
5
6
2
1
8
4
3
12
6
1
5
1
4
1
13
11
10
9
R
P
P
P
M
M
N
N
