Page 23 of 35
www.vacgen.com
+44 (0) 1424 856 333
* With the Z-slide at either extreme of travel, measure the height of the translator above the track at
the outer end. Repeat this measurement when the travel is at the other extreme. A difference greater
than 5mm may indicate that further adjustment is necessary. Consult the factory.
* The base of the end compensator and the track must be bolted firmly in position.
Caution.
Protect the OMMAX and its compensation units from accidental knocks tha
t could dislodge
the push rods and over-stress the system flange.