ENGLISH
8
ELECTRICAL CONNECTION TABLE
L1
Antenna
L2
Antenna shield
L3
Opening command for a standard connection device
with switch normally open.
L4
Pedestrian opening command for a standard
connection device with switch normally open.
L5
STOP command. N.C. switch
L6
Photocell. N.C. switch
L7
Edge. Switch N.C. or resistive rubber edge
L8
Commands common (-) line
L9 - L10
24 VAC power output for photocells and other
accessories
L10 - L11
Power supply for functional test TX photocell
K1 - K2
Courtesy light timer activation switch
K3
Motor 1 open
K4
Motor 1 common
K5
Motor 1 close
K6
Motor 2 open
K7
Motor 2 common
K8
Motor 2 closed
K9 - K10
230V - 40W / 120V - 40W blinker
N
230V / 120V power supply - neutral
L
230V / 120V power supply - phase
J1
NOT USED
ADJUSTMENT OF THE POWER AND
OPERATIONAL TIMES
The power and operating times may be adjusted by means of 4
trimmers located on the control unit:
POWER:
motor power.
WORK:
motor operating time (5 - 120 seconds).
m
PLEASE NOTE:
it is recommended that operating times be
set with the slow down function disabled (DIP 5 OFF).
PAUSE:
pause time before automatic re-closure
(5 - 120 seconds).
DELAY:
time delay between the two gate leaves
(0 - 60 seconds).
CONTROL UNIT INDICATORS (LEDS)
The highlighted boxes indicate the state of the LEDs when the
gate is resting.
m
PLEASE NOTE:
If
not used, the normally
closed inputs (STOP,
PHOTO, EDGE) must be
jumpered with the
commands common line
COM (-)
LED
ON
OFF
START
START input closed
START input open
IN2
START P. input closed
START P. input open
STOP
STOP input closed
STOP input open
PHOTO
PHOTO input closed
PHOTO input open
EDGE
Standard edge
EDGE input closed (edge
not pressed)
EDGE input open (edge
pressed)
Resistive rubber edge
EDGE input closed (edge
pressed)
EDGE input open
(fault)
Edge NO pressed: 8K2
between EDGE input
and common (-)
mains
Control unit powered-up Control unit NOT powered-up
overload
Accessory power supply
overload
Accessory power supply within
normal operational limits
J1
