Fig. 26
u
Attach fastening crosspiece Fig. 26 (11) to the inside of
the unit door using the assembly aids Fig. 26 (12).
u
Align the crosspiece Fig. 26 (11) in the middle of the door.
w
Distances to the outer edge are equal at the left and
right.
For chipboard doors:
u
Secure the fastening crosspiece Fig. 26 (11) with at least
6 screws Fig. 26 (19).
For frame and panel doors:
u
Secure the fastening crosspiece Fig. 26 (11)with 4 screws
Fig. 26 (19) at the edge.
u
Raise the assembly aids Fig. 26 (12) for removal, turn
them and insert them into the adjacent openings.
Fig. 27
u
Attach the unit door to the adjusting bolts Fig. 27 (13) and
loosely screw the locknuts Fig. 27 (10) onto them.
u
Close the door.
u
Check the gap between the door and the surrounding
unit doors.
u
To laterally align the door: push unit door in X direction.
u
To align the door vertically Y and in the lateral inclination:
adjust adjusting bolts Fig. 27 (13) with a screwdriver.
w
The unit door is flush and in alignment with the
surrounding unit fronts.
u
Tighten locknuts Fig. 27 (10).
Fig. 28
u
To screw the unit door to the appliance door:
u
Drill pilot holes in the door of the unit (possibly make
preliminary holes with a bradawl).
u
Screw the appliance door to the cabinet door using the
fixing bracket.
Fig. 29
u
Align the cabinet door to the height marked Z: loosen the
screws at the top and bottom of the door, then adjust the
door.
u
Open the door to approx 45° so you can easily access the
screws under the door.
u
Do not allow knobs and sealing
lips to make contact - important
for function!
u
Allow an air gap of 2 mm between
the unit door and the body of the
unit.
Fig. 30
u
Check the fit of the door and readjust if necessary.
u
Tighten all screws.
u
Tighten lock nuts Fig. 30 (10) with a no. 13 Allen
key, making sure you counterhold the adjusting bolts
Fig. 30 (13) with a screwdriver.
Fig. 31
u
Fit the top cover and click into place.
Check the following points to ensure the appliance is fitted
properly. Failure to do so may lead to icing, condensate
forming and malfunction:
w
The door has to close properly
w
The unit door must not butt against the unit body
10 Disposing of packaging
Disposing of packaging
10
* Depending on model and options