Installing
1. Unscrew cover C.
2. Put motor housing A on hood body B. Ensure that
no cables are trapped.
Caution: Protect glass.
3. Screw 6 screws S1 (ø 3.5 × 6 mm) in motor housing
A.
4. Remove short-circuit plug of motor housing A and
connect to plug of hood body B. Connect the other
2 motor housing plugs to the plugs of the hood body.
3 plug connector pairs must be connected in total.
WARNING: Failure to install the screws or fixing
device in accordance with these instructions
may result in electrical hazards.
5. Stow cable and plugs in hood body B and mount
cover C using screws S2 (ø 3.5 × 6 mm).
6. Fix each of the 2 angle brackets E with 2 screws S3
(M4 × 15 mm).
7. If necessary: Set compensator G using 4 screws S4
(ø 3.5 × 6 mm) to correct wall unit depth.
8. Attach paper template to wall unit and prick and
bore 4 holes for screws S5.
9. Fix each of the 2 angle brackets H with 2 screws S5
(ø 4.3 × 12.5 mm) to wall unit.
10. Only for 'Front cover' accessory (H4.2614/H4.2615):
Mount angle for front cover (see section on 'Front
cover' in Installation instructions).
A
E
B
S1
S1
C
S2
S3
S3
E
S2
S4
S4
G
H
S5
D
Installation instructions
J61001.113-1
Range hood DFPQ5/DFPQ6/DFPQ9/DFPQ12
09.10.13
Built-in hood
Operating modes: extracted air/recirculation air
4
