8 Care and maintenance
Fitting the door seal
The joint and vent hole
X
must be at the left in the middle.
▸ Fit the seal starting in one of the corners at the
top.
▸ Insert the clip from the outside to the inside at
a 30° angle into the slot. Once the seal is fitted
at the top, insert the bottom two clips.
▸ Press the door seal into the groove all around,
i.e. at the top, bottom, left and right.
1.
2.
3.
4.
X
8.7
Replacing the halogen light bulb
WARNING: Risk of electric shock!
Disconnect the appliance from the mains power supply before replacing the halo-
gen light bulb.
Risk of burns from hot surfaces!
Allow the halogen light bulb and the appliance to cool down before replacing the
halogen light bulb.
Do not touch the halogen light bulb with bare hands. Instead, use a fine, dry,
grease-free cloth.
Overhead illumination
▸ Carefully turn the glass light cover
1
clockwise
and remove.
▸ Take out the faulty halogen light bulb.
▸ Carefully fit the new halogen light bulb.
▸ Turn the glass light cover
1
anti-clockwise to
tighten.
▸ Reconnect the power supply.
1
Lateral illumination
▸ Remove the left shelf guide.
▸ Place the screw driver along the middle of the
edge of the glass and carefully remove the
glass light cover
2
from its fixture.
▸ Take out the faulty halogen light bulb.
▸ Carefully fit the new halogen light bulb.
▸ Press the glass light cover
2
back into its fix-
ture.
▸ Replace the shelf guides.
▸ Reconnect the power supply.
2
45