26 / DE
Masina de spalat automata / Manual de utilizare
8
Problemlösung
Problem
Ursache
Lösung
Programme starten nicht,
nachdem die Tür geschlossen
wurde.
Start/Pause/Abbrechen-Taste wurde nicht gedrückt.
• Drücken Sie die Start-/Pause-/Abbrechen-Taste.
Möglicherweise lässt sich die Gerätetür bei
übermässiger Beladung nur schwer schliessen.
• Reduzieren Sie die Wäschemenge und stellen Sie
sicher, dass die Gerätetür richtig schliesst.
Programme lassen sich nicht
starten oder auswählen.
Das Gerät schaltete sich aus Sicherheitsgründen
selbst ab; dies kann äussere Ursachen (z. B.
Schwankungen von Spannung, Wasserdruck etc.)
haben.
• Setzen Sie die Maschine auf die
Werkseinstellungen zurück, indem Sie die Ein/
Aus-Taste 3 Sekunden lang gedrückt halten.
(Siehe „Programme abbrechen“.)
Es befindet sich Wasser in der
Maschine.
Eventuell befindet sich noch etwas Wasser in der
Trommel. Dies liegt daran, dass das Gerät vor der
Auslieferung noch einmal gründlich geprüft wurde.
• Dies ist kein Defekt – natürlich wird Ihre
Waschmaschine nicht von Wasser beeinträchtigt.
Das Gerät zieht kein Wasser.
Der Wasserhahn ist geschlossen.
• Drehen Sie die Wasserhähne auf.
Der Wasserzulaufschlauch ist geknickt.
• Begradigen Sie den Schlauch.
Der Filter im Wasserzulauf ist verstopft.
• Reinigen Sie den Filter.
Die Gerätetür ist nicht geschlossen.
• Schliessen Sie die Tür.
Das Wasser fliesst nicht aus der
Maschine ab.
Der Wasserablaufschlauch ist verstopft oder geknickt.
• Reinigen oder begradigen Sie den Schlauch.
Der Pumpenfilter ist verstopft.
• Reinigen Sie den Pumpenfilter.
Die Maschine vibriert stark oder
arbeitet sehr laut.
Die Maschine steht nicht gerade.
• Stabilisieren Sie die Maschine, indem Sie die
Füsse entsprechend einstellen.
Ein Fremdkörper ist in den Pumpenfilter eingedrungen.
• Reinigen Sie den Pumpenfilter.
Die Transportsicherungen (Bolzen) wurden nicht
entfernt.
• Entfernen Sie die Transportsicherungen (Bolzen).
Es befindet sich zu wenig Wäsche in der Maschine.
• Geben Sie mehr Wäsche in die Maschine.
Es befindet sich zu viel Wäsche in der Maschine.
• Reduzieren Sie die Wäschemenge in der
Maschine oder verteilen Sie die Wäsche von Hand
gleichmässiger.
Die Maschine stösst irgendwo an.
• Achten Sie darauf, dass die Maschine frei steht.
Wasser tritt aus dem unteren Teil
der Maschine aus.
Der Wasserablaufschlauch ist verstopft oder geknickt.
• Reinigen oder begradigen Sie den Schlauch.
Der Pumpenfilter ist verstopft.
• Reinigen Sie den Pumpenfilter.
Die Maschine stoppt kurz nach
Programmbeginn.
Die Maschine hält vorübergehend an, wenn die
Spannung zu niedrig ist.
• Die Maschine setzt den Betrieb fort, wenn die
Spannung wieder den Normalwert erreicht hat.
Gleich nach dem Einlaufen wird
das Wasser wieder ausgestossen.
Der Ablaufschlauch befindet sich nicht in der richtigen
Höhe.
• Schliessen Sie den Wasserablaufschlauch genau
wie in der Bedienungsanleitung beschrieben an.
Beim Waschen ist kein Wasser in
der Maschine zu sehen.
Wasser befindet sich im nicht sichtbaren Bereich der
Maschine.
• Dies ist kein Problem.
Die Waschmaschinentür lässt sich
nicht öffnen.
Die Türsperre ist aktiv, da das Wasser recht hoch in
der Maschine steht.
• Entfernen Sie das Wasser mit dem Abpumpen-
oder Schleudern-Programm.
Die Maschine heizt gerade das Wasser auf oder
befindet sich im Schleudergang.
• Warten Sie, bis das Programm abgeschlossen
ist.
Die Gerätetür klemmt möglicherweise aufgrund des
Drucks, dem sie ausgesetzt ist.
• Greifen Sie den Griff, drücken und ziehen Sie die
Gerätetür zum Lösen und Öffnen.
Bei einem Stromausfall lässt sich die Gerätetür nicht
öffnen.
• Öffnen Sie sie von Hand, indem Sie die
Pumpenfilterkappe öffnen und den Notgriff an der
Rückseite besagter Kappe nach unten ziehen.
Siehe „Gerätetürsperre“.