V-TUF XR11000, Руководство оператора, Страница: 10 / 18

10
IMPORTANT INFORMATION
Never use the machine if you are unsure, or become uncertain due to any faults of any kind, including
those not mentioned in this manual.
Model XR11000
Capacity 110 Litres
Working Voltage
110 & 240 Volts
Motor Power 2400/3600 Watts
Function Wet & Dry Vacuuming
Air Flow Rate 106 L/SEC
Cooling Mode 250mm
Tank Diameter 370mm
Height 970mm
Accessories Ø38mm Accessories Kit
Power Cable 5m
Technical Information
OPERATION INSTRUCTIONS
1. Ensure that there is sufficient ventilation for the machine and the operator
2. Make sure the machine on a sound and stable surface.
3. Ensure the machine is switched to the off position, connect to the correct and sufficient power source,
switch machine on, use according to the guidelines and turn machine off after operation.
IMPORTANT
1. The wet and dry machines feature a floating valve that interrupts the vacuum when the tank is full of
liquid. When this occurs, turn the machine off and empty the entire contents of the tank.
2. Do not use your machine if it is not functioning correctly. Regularly inspect electrical leads and
connections, filters and listen for unusual noises. If in doubt, contact your nearest service centre for
advice.
MAINTENANCE
MAINTENANCE
1. The filter element can be blown clean OR washed with water.
Ensure that it is completely dry before the operation.
2. Replace the vacuum filter if it acquires holes, torn or damaged.
Holes and/or cuts on the sides of the filter could allow transit of
dust / materials and become the cause of serious damage to the
user and surrounding people, and the appliance.
3. Check and free the blocked parts (vacuum pipes, connector,
brushes, etc.) from any deposited materials.
4. If necessary, clean the tank and in any case, never leave dust
or liquid residues in the tank for long periods of time.
5. Fires can be started by excess flammable dust, so it is recommended for the vac head to
be blown out with air periodically. Blast the inlet to motors with air and blast the exhaust ports
with air. (See image)
6. If the filters have not been fitted correctly and the dust has gone through the motors, undo
the 5 screws on top of the machine and blast the area under the cover and the fans of the
motors clean.