OEM TM-50 Quick Start Guide
D291720.5c
Page
2
of
6
Rev.
3,
10/17/17
Assembly
1.
Attach the Cover Tape Arm
Using a 3/16” hex wrench, remove the (2) 1/4” SHCS located on the backside of the loading
track. Bolt the
Cover Tape Arm
(1a)
to the track support bracket.
There are (2) amplifiers also located on the back side of the loading track
.
Lift the top of the
Amplifier
(1b)
closest to the track to access the small grey switch inside. Push the switch UP,
and then insert the double-pronged fiber optic cable from the cover tape arm into the matching
opening on the amplifier.
2.
Attach the Take-up Spindle
Attach the
Take-up Spindle
(2a)
to the
Take-up Motor Assembly
(2b)
by sliding it onto the
pin and tightening the set screw with a 3/32” hex wrench.
3.
Attach the Take-up Arm
Remove the black knob from the left side of the track support bracket. The take-up arm has a
dowel pin which locks into position holes on the track support bracket. Slide the
Take-Up Arm
(3a)
onto the threaded rod, engage the dowel pin into the desired position, and secure it into
place with the black knob. Plug the electrical connector into the
Take-Up Motor Receptacle
(3b)
.
4.
Attach the Payout Arm
Remove the black knob from the right side of the track support bracket. The
Payout Arm
(4)
has a dowel pin which locks into position holes on the track support bracket. Slide the feed reel
support arm onto the threaded rod, engage the dowel pin into the desired position, and secure
it into place with the black knob.
5.
Attach the Tape Guide
Remove the (4) 8-32 x ¾” BHCS
(5a)
which attach the
Pulley Mounts
(5a)
to the
Pulley
Covers
(5c)
.
Remove the (4) 8-32 x ¾” BHCS from the top of the (2) pulley mounts
and insert them in the
bottom of the
Pulley Mounts
(5d)
. Use the BHCS to attach the pulley mounts to the right end
of the
Loading Track
(5c)
.
Attach the (2) pulley covers to the pulley mounts using the (4) 8-32 x ¾” BHCS.
4
2a
2b
3a
1a
1b
3b
5e
5d
5a
5b
5c
