V-fit FC2790-UK, Сборка и руководство пользователя

Страница: 18 / 24

2
Note
Assembly
Assembly of this stage
may be easier with 2 people
Pass the Tension Cable (20) up the Handlebar Upright (2) and out
through the Control Knob mount hole on the upper right side of the
Handlebar Upright (2). Connect both ends of the Lower Exercise
Monitor Wire (15) and the Exercise Monitor Link Wire (14)
together – pushing firmly to ensure a good connection.
A-1. Hold the Tension Cable (20) below the metal bracket. Guide the
lower parts of the INNER cable of the Tension Adjustment Knob (19)
into the formed metal loop on the INNER Cable of the Tension Cable.
A-2. Still holding the Tension Cable (20), pull the Tension Adjustment Knob
(19) away from the Metal Bracket (you will notice some resistance at this
stage) and guide the INNER cable through the open slot in the Metal Bracket.
A-3. Slowly release the tension on the UPPER cable and guide it carefully
into the hole in the top of the Metal Bracket.
Fit the Handlebar Upright (2) into place on the Main frame (1) using 1 x M8
x 67mm Hex Bolt (48), 2 x M8 Flat Washer (21) and 1 x M8 Nylon Lock Nut (22).
Raise the Handlebar into its upright position. Tighten the Hex Bolt (48) and Locking
Knob (53). Cover the head of the Bolt (48) and Nut (22) with the 2 x Plastic Cover (47).
Turn the Tension Adjustment Knob (19) to position “8” to remove any slack
in the Tension Cable Assembly and fit the Tension Adjustment Knob (19) into
the Handlebar Upright (2) pushing Firmly into position and secure in place using
1 x M5 x 40mm Screw and 1 x M5 Curved Washer removed from the Tension
Adjustment Knob (19).
Page 18
20
2
14
14
15
15
14
15
4847
20
19
21
7 4 2
53
56
2
19
21
16 50