UZIN 16876, Перевод оригинальной инструкции

Страница: 17 / 28

17
6.2 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
7.0 Troubleshooting
Fault Possible cause Remedy
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable
must be collected separately and disposed of in an envi-
ronmentally correct manner.
Subject to change without notice
9.0 Notes on various fl oor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The JUNIO-STRIPPER is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
► Needle-punched fl oor covering, carpet, PVC…..
The coverings to be removed should be pre-cut in
blade-widths (Pic. B) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (Pic. B). Regularly check
whether the blade is still straight and sharp.
► Coverings with a foam backing:
Only use sharp blades! Remove the large Sections of
the wearing surface. Use a carpet pulling claw for this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from the
side.
► Coverings with a fl eece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with the
fl eece backing.
Important blade recommendation:
In general, no statements can be made on which
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
► We recommend using fl at blades of varying lengths
and widths for fl exible, elastic fl oor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
Warning
Contact Electrici-
an.For repair and
/or replace parts
Replace knife
Send in the ma-
chine for repair
Replace the coal
in the service
workshop
The machine
does not start Power supply
interrupted
Defective cable
Defective plug
Higher exer-
tion of force
required while
working Knife blunt
high vibration Wear parts of
the machine are
knocked out
The machine
turns off Coal is worn out
EN