GelCam 310
3
1. Align the holes of the gasket and base. Attach
the base and gasket to the darkroom using the
screws provided. Position the bracket on the
mounting base aligning the holes on the base.
Using the four thumb screws provided, secure the
bracket to the base.
2. Place the camera and lens assembly into the
camera bracket. Push the lens through the center
hole in the gasket. The gasket forms a seal
around the lens. Insert and tighten the
knob/washer to secure the camera to the bracket.
Be sure to position the knob in the central hole in
the camera (refer to the photo callout below).
3. Plug the 90 degree cable into the top of the
camera. Leave the other end unplugged until
ready to install the Visionworks disk.
Photo to the right shows the center hole for the
knob connection.
