Manufacturer: UVI Group Corporation GSM Car Alarm System with GPS Car Tracking (GPS-118V)
-7/18-
Step on foot
brake
Calling to car
owner
：
Warning, engine
started
Footbrake trigger
N(S)
XX.XX.XX
E(W)X
XX.XX.XX
VXX.X
DXXX.XX
Power off
Calling to car
owner
：
Warning,
power off
Power off
N(S)
XX.XX.XX
E(W)X
XX.XX.XX
VXX.X
DXXX.XX
Emergency help
Calling to car
owner: Hijacked,
please help
Help
N(S)
XX.XX.XX
E(W)X
XX.XX.XX
VXX.X
DXXX.XX
Arm the car
Siren interval
beep 3 times, turn
light flashing
Please arm
N(S)
XX.XX.XX
E(W)X
XX.XX.XX
VXX.X
DXXX.XX
1. These alarm above will continue if the trigger alarm continues.
2. In case of any alarm, this system will call the 1
st
phone number. Not answered, it will call the
2
nd
phone number. The call will continue by turns, which will never stop until one of these calls is
answered. At the same time, system sends short message to these numbers. If the 1
st
phone is
answered, there will be no short message to the 2
nd
phone number.
3.5 Third Alarm Phone Number (optional)
This system can hold 3 alarm phone numbers if it is needed.
3.6 Alarm Report
If there is another alarm trigger when the previous alarm phone is answered, this system will
report the latest alarm immediately. However, the shock trigger alarm will not be reported when
there is another alarm.
3
.7
、
、
、
、
Alarm priority
When connected the GSM mainframe, alarming happened before enter the password .the
connection would be but automatically .then dial the number to alarm phone that used set.
3.8 Reminding to Set the Phone Number Beforehand
This system will remind the owner to set phone number before setting a password to treat the
emergency when car owner forget the password. The voice instruction is “Please set up phone
number.”
3.9 Safety Reminding (optional)
After the ignition is turned on, the system will speak “Pleas wear your seat belt.”
3.10 Dialer/Remote Control Learning Code
Close the door, and step on foot brake. Turn the key from OFF to ON for 3 times and stop in
the position of ON. When turn light flash 5 seconds, press any button of dialer. Turn light will flash
3 times, and siren beeps 3 times. Dialer learned code successfully.
3.11 Reporting Incoming Telephone Number
