Waste Management Center for proper disposal procedure.
10
ALTERNATIVE CUTTING METHOD
1. Using the Adhesive Gasket Plate,
trace the hole locations onto the
duct.
2. Drill holes around the outside
edges of the previously marked
holes but inside the outer holes of
the Adhesive Gasket Plate.
3. Use the Tin Snips to cut out the space
around the marked holes.
9
ELECTRICAL REQUIREMENTS
To use the 120V plug, be sure to locate the unit within 6ft. of a
standard 120V grounded outlet. Long term use of an extension cord
is not recommended due to safety considerations.
HARDWARE REQUIREMENTS
Permanent wiring of the unit into your HVAC
system or installations using a 220V plug (not
included) should be done by a licensed HVAC
Installer or Electrical Contractor only.
For 110V and 220V Applications: Black = L1,
White = Neutral, Green = Ground
For International Applications: Brown = L1,
Blue = L2, Green / Yellow Stripe = Ground
Ux510 INSTALLATION
1. Hang the Ux510 from the ceiling using chain or hanger that
will support 39 pounds. Use holes in base of unit for
hanging.
2. Electrical requirements are: 120 VAC, 60 Hz or 220 VAC, 50
Hz
3. Airflow is 262 cfm.
