Lineman driven. Field proven.
U
TILITY
S
OLUTIONS
™
2
USJL-001 Manual Rev. 1.5 (3-6-14)
BEFORE Installing
Visually inspect the tool to verify that the protective cable is not cut or damaged.
Prior to installation of the USJL-001 ensure that all four insulated handles
are in the receiving position. This means that the insulated handle has been
unthreaded so that the copper attachment ferrule is just barely recessed inside
the black insulated handle. The ferrule should not protrude from the insulated
handle.
Also prior to installation ensure that the ferrule, when in the receiving position,
has a wide enough attachment slot opening. If necessary unthread the ferrule
past the insulated handle and use a large flat head screwdriver to open the slot
accordingly.
Installation, Removal and Storage
1.
Remove the Meter Enclosure Cover.
2.
Push one end of a jumper lead ferrule over the load side bypass horn until
fully seated.
3.
Turn the insulated handle clockwise until the jumper ferrule firmly clamps
onto the bypass horn.
4.
Push the corresponding jumper lead ferrule over the source side bypass
horn until fully seated.
5.
Turn the insulated handle clockwise until the jumper ferrule firmly clamps
onto the bypass horn.
6.
Repeat the same process for the other side of the meter base
with the remaining jumper lead.
7.
Verify that the jumper leads are secure and will not interfere with
the removal of the meter.
8.
Remove the meter.
9.
After the meter has been replaced remove the jumper leads
one side at a time. Unthread and remove the insulated handle
attached to the load side first followed by the corresponding
source side ferrule.
10. Repeat the same process for the other side of the meter base.
Warranty
Utility Solutions, Inc. warrants the Electric Meter Jumper Lead Set for any defects in manufacturing
for the period of one year. If the tool is returned within that time period, Utility Solutions, Inc. will
replace the tool free of charge.
!
!
DANGER
Contact with high voltage will cause death or
grievous personal injury to the operator. Only
use this device in conjunction with safe operating
practices around energized lines and equipment.
!
!
WARNING
Only utilize this tool while wearing appropriate
rated gloves and personal protective equipment.
