WIRING FIXTURE
(Product May Vary from Illustration)
White to White
Black to Black
Fixture ground to
junction box ground.
© 2007 HeathCo LLC
598-1298-01
Canopy
Quartz Halogen
Floodlight
Questions or problems?
Before returning to your retailer, call our
technical service department at 1-800-858-8501 (English speaking
only), 7:30 am to 4:30 pm, CST, Monday – Friday.
This quartz halogen fl oodlight disperses light over a wide area, at-
taches to a standard junction box and is for use with 120 VAC.
PACKAGE CONTENTS
• Floodlight
• Bulb
• 2 Rubber plugs
• Gasket
• Wire
connectors
• Mounting
hardware
READ ALL INSTRUCTIONS CAREFULLY BEFORE
BEGINNING INSTALLATION.
NOTE:
All wiring must be run in accordance with the National
Electrical Code through conduit or another acceptable
means. Contact a qualifi ed electrician if there is any ques-
tion as to the suitability of the system.
FIXTURE INSTALLATION INSTRUCTIONS
Estimated Installation Time: 30 minutes
Items needed for installation (not included):
• Phillips and fl athead screwdrivers
• Pliers
• Wire
strippers/cutters
• Safety glasses
• Silicone caulk
• Ladder
• Black
tape
To avoid Electrical Shock:
CAUTION to avoid fi re or burn hazards:
• Allow fi xture to cool before touching. The bulbs and fi xture
operate at high temperatures.
• Keep fi xture at least 2" (51 mm) from combustible materials.
Do not aim at objects closer than 3 feet (1 m).
• Replace bulb with up to 150W (max.) T3 halogen 120 VAC bulb
only.
WARNING: Turn power off at the circuit breaker or
fuse.
Item
Model
247590
UT-5571-BZ
• Follow all warnings listed on fi xture.
• Grounding and installations must comply with local codes and
the National Electric Code.
• This product should be mounted on a grounded junction box and
must be used with the canopy included.
• Permanently mount the fi xture to a building or pole.
1. Thread aiming arm into the enclosed canopy and tighten. Apply
silicon caulk to joint for a raintight seal. Seal the remaining holes
with the enclosed canopy plugs.
2. Connect the fi xture wires to the power source wiring. Secure
with wire connectors.
3. Attach the canopy to the junction box (Apply silicon caulk be-
tween canopy and junction box for a raintight seal). Keep the
fi xture horizontal (/- 4º) so the bulb inside is horizontal.
If the bulb is not horizontal, the bulb may darken or shatter
and fail prematurely.
1. When replacing bulb,
turn power off
and let the fi xture cool.
2. Remove glass cover and remove the old bulb by pushing the
bulb towards the right until the left side of the bulb is clear of
the left socket.
3. To insert the new bulb push the bulb into the right socket so the
bulb is properly seated in the sockets.
4. Re-install the glass cover.
5. Reconnect the power.
IMPORTANT:
Use a clean glove or cloth when handling the
new bulb. Oil from your hand may cause the bulb to crack when
the fi xture heats up and result in premature failure. Use isopro-
pyl (rubbing) alcohol to clean the bulb if it is touched with your
bare hands.
4. Loosen the side bolt connected to the arm to aim the fi xture up
and down.
5. To avoid water entering fi xture, do not aim the fi xture above the
horizon.
BULB INSTALLATION AND REPLACEMENT
