3. Use only your hand to move the ignition
system control switch. Never use tools.
If the switch will not move by hand, don’t
try to repair it, call a qualified service
technician.
W
W
W
W
WARNING:
ARNING:
ARNING:
ARNING:
ARNING:
FORCE OR
ATTEMPTED REPAIR MAY RESULT
IN A FIRE OR EXPLOSION.
4. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect
the appliance and to replace any part of
the control system and gas control which
has been under water.
“OPERATING INSTRUCTIONS”
“OPERATING INSTRUCTIONS”
“OPERATING INSTRUCTIONS”
“OPERATING INSTRUCTIONS”
“OPERATING INSTRUCTIONS”
1. STOP! Read the safety information in the user’s information manual.
2. Set thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device which automatically lights the pilot. DO
NOT try to light the pilot by hand.
5. Move the ignition system control switch to the "OFF" position. See figure 10 above.
6. Wait five (5) minutes to clear out any gas. If you then smell gas, STOP. Follow step 2
in the lighting procedure on page 10, "What To Do If You Smell Gas." If you don't smell
gas, go to the next step.
7. Move the ignition system control switch to the "ON" position. See figure 10 above.
8. Turn on all electric power to the appliance.
9. Set thermostat to desired setting.
10. If the appliance will not operate, follow the instructions "
TO TURN OFF GAS TO
APPLIANCE
" (Below) and call a qualified service technician or your gas supplier.
TO TURN OFF GAS TO APPLIANCE
TO TURN OFF GAS TO APPLIANCE
TO TURN OFF GAS TO APPLIANCE
TO TURN OFF GAS TO APPLIANCE
TO TURN OFF GAS TO APPLIANCE
1. Set thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to be performed.
3. Move the ignition system control switch to the "OFF" position.
DO NOT FORCE
PAGE 11
FIGURE 10