UTICA BOILERS MAGB, Руководство по установке и эксплуатации

Страница: 18 / 32

LIGHTING PROCEDURE FOR BOILER WITH
CONTINUOUS PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
A. Read the warning at the beginning of the LIGHTING INSTRUCTIONS
B. This appliance has a pilot which must be lighted by hand. When lighting the pilot,
follow these instructions exactly.
C. Before lighting, smell all around the appliance area for gas. Be sure to smell next to
the floor because some gas is heavier than air and will settle on the floor. See the beginning
of these instructions for WHAT TO DO IF YOU SMELL GAS.
D. Use only your hand to push in or turn gas control knob or reset button. Never use tools.
If the knob or reset button will not push in or turn by hand, don’t try to repair it, call a qualified
service technician. Force or attempted repair may result in a fire or explosion.
E. Do not use this appliance if any part has been under water. Immediately call a qualified
service technician to inspect the appliance and to replace any part of the control system
and any gas control which has been under water.
LIGHTING INSTRUCTIONS FOR CONTINUOUS PILOT
1. STOP! Read the safety information at the beginning of these instructions.
2. Set the thermostat to the lowest setting.
3. Turn off all electric power to the appliance.
4. Remove access panel (if present) and burner door.
5. Turn gas control knob clockwise to "OFF". See figure 9 below.
NOTE #1: Some gas control knobs cannot be turned from "PILOT" to "OFF" unless
knob is pushed in slightly. DO NOT FORCE.
6. Wait (5) minutes to clear out any gas. If you then smell gas, STOP! Follow “for your
safety what to do if you smell gas”, at the beginning of these instructions. If you don't smell
gas, go to the next step.
7. Find pilot. Follow metal tube from gas
control. Depending on the model of the boiler,
pilot is either mounted on the base or on one
of the burner tubes.
8. Turn gas control knob counterclock-
wise to "PILOT".
9. Push in gas control knob or reset
button if so equipped, all the way in and hold.
Immediately light the pilot with a match.
PAGE 17
FIGURE 9
CONTINUOUS PILOT GAS VALVE