连接接口
100Mbps/Gigabit Fiber Media Converter
3
4
400-700-5088
www.utepo.com
Fiber
Data
Communication
Products
：
M O D E L
QUALIFIED
CERTIFICTE
MOD E L
：
MODEL
：
Explanation for LED indicator lamp
Transmission characteristics of single fiber transceiver
连接接口
Trouble shooting
LED indicator lamp
1000M
100M
FX
Link/Act
TX
Link/Act
FDX
PWR
Status
Explanation
Current RJ-45 rate is Gigabit
Current RJ-45 rate is 100 megabits
“ON” indicates that fiber port is in correct connection.
On
Blink
Blink
Product model
MC2-FS
MC2-GS
Optical wavelength
(nm)
1310/1550
1550/1310
1310/1550
1550/1310
-12~-3
-6-10
-36
-23
1310nm:0.4
≥-3
1550nm:0.25
Technical parameters
MC2
-
FS/MC2
-
GS
Standard Protocol: IEEE802.3 10 Base-T standard
IEEE 802.3u 100Base-TX and IEEE802.3z standard
Connector: one UTP RJ-45 connector, one SC connector
Operation mode: full duplex mode or half duplex mode
Power supply parameter:
Adapter(External): 100-240V AC input, 5V0.6A DC output
Environmental temperature: -20
℃
- 60
℃
Relative humidity: 5%-90%
TP cable: Cat5 UTP cable
Transfer fiber:
multi-mode: 50/125, 62.5/125 or 100/140
μ
m
single mode: 8.3/125, 8.7/125, 9/125 or 10/125
μ
m
Dimensions:
Power external: 94mm(L)x 71mm(W) x 26mm(H)
LED indicator lamps serve as device monitoring and trouble display. The following is the
explanation for each LED indicator lamp.
On
On
On
Off
On
Off
“Blink” indicates packet goes through media converter
“ON” indicates that RJ45 port is in correct connection.
“Blink” indicates packet goes through media converter
Transceiver works in the full duplex mode.
Transceiver works in the half duplex mode.
Power is on and normal.
Transmitting optical power
(dBm)
Receiving sensitivity
(dBm)
Saturability
(dBm)
1. Device is not matched. Please select the corresponding network device according to the
transfer rate of the product (10Mbps or 100Mbps, 1000Mbps) when connected to other
network devices (network card, hub, switch).
2. Line loss is excessive during the fiber wiring. Excessive loss in connector plug-in and
fiber soldering welding, and excessive intermediate nodes may cause excessive loss rate
or abnormal operation.
make
everything
simpler !
PRODUCT WARRANTY CARD
