background image

 

1

 

ESS, Inc. 

 

203 McMillin Street 

 

Nashville TN 37203 

 

615-340-9033 

 

We Are Always At Your Service! 

 
 

MIXHITS iSTREAM2 

Installation Instructions 

 
Congratulations on choosing MixHits Radio for your in-store music source!  Here are some basic 
instructions for installation.  Should you have any questions, please don’t hesitate to call us. 
 
When you open the box, you should find the following: 
 

 

 

-  Your new Mixhits player 
-  The power supply 
-  An Ethernet cable  
-  A black RCA cable  
-  A RCA “Y” adapter  
-  The manual from the manufacturer. 

 

Содержание MIXHITS iSTREAM2

Страница 1: ...ns on choosing MixHits Radio for your in store music source Here are some basic instructions for installation Should you have any questions please don t hesitate to call us When you open the box you should find the following Your new Mixhits player The power supply An Ethernet cable A black RCA cable A RCA Y adapter The manual from the manufacturer ...

Страница 2: ...nect one end to the power inlet and plug the other end into a normal power outlet on the wall Second you will need to use the Ethernet cable to connect from your player s LAN port to an Ethernet switch or HUB so that the player can access the internet to receive music content Last you will need to connect the black RCA cable from the STREAMING OUTPUT jack to your existing amplifier Once this is co...

Страница 3: ...ront of your amplifier using the Aux or Program volume knob If your amplifier has more than one Aux jack you should be able to use any of them Just make sure that you are adjusting the corresponding knob on the front Some amplifiers have a switch that says Mic Aux Make sure that the switch is in the Aux position 2 If your amplifier does not have a RCA type jack then you will have to connect it dif...

Страница 4: ...re mesh back revealing the small insulated wire in the center and twist the mesh together Then carefully pull off about inch of the insulation on the center wire and twist it also Attach the very small center wire to the Program hot connection and attach the twisted outer mesh to the Program com connection Make sure to not break the wires or allow them to touch together You should now be able to a...

Отзывы: