9
ELECTRICAL CONNECTIONS
The unit is equipped with a series of auxiliary commands for various functions, which can be enabled or disabled depending on the needs. The functions
are located in the terminal strip of x2 'units. Below are listed the individual functions in detail.
Temperature required
The temperature required contact, enable the unit in summer or winter integration operation. it is possibile to connect a room thermostat that enables the
function at the time of request. If you use the remote control panel to set the set of comfort, leave the jumper in the terminal strip X2.
Humidity request
The request Humidity contact, will enable the unit in the operation of summer or winter dehumidify. it is possible connect an ambient humidistat that will
enable the function at the time of request.
On-Off Remote
The on-off remote, allows you to turn on or turn off the unit with a clean electrical contact. It can 'be useful to turn off the entire unit in moments of inactivity
avoiding energy consumption.
Change Summer-Winter remote
The summer - winter remotely, allows you to change the season and the work logic of the unity through a dry contact.
Operation Only Ventilation
Through the only opening of the contact of the fan, the unit will exclude out any type of adjustment on dehumidification and integration.
REMOTE PANEL CONNECTION
The installation must be done by trained personnel. For optimum operation, the remote panel must be fixed to a Internal wall, about 1.5 m above the floor,
away from heat sources (radiators, stoves etc.) and should not be exposed to direct sunlight. Not should be installed near doors slamming may destroy the
electronics.
The connection of the remote control panel is through the connection with 3-wire cable and Belden 8772 cable (3xawg20) The maximum distance betwe-
en the controller and interface is mt.150. The 31-32-33 terminals are for the terminal connection (see wiring diagram).
