UTC Fire and Security interlogix 60-928, Инструкция по установке

Страница: 3 / 3

Figure 9: Optional antenna configurations
Specifications
Insert Through Silicone
Plugs
Insert Antenna into
Antenna Holes in
Housing
Attach O-Rings to
Antenna Housings
Outside dimensions 6.82 x 6.50 x 2.00 in. (W x H x D)
(17.32 x 16.51 x 5.08 cm)
Inside dimensions 6.40 x 5.50 x 1.92 in (W x H x D)
(16.26 x 13.97 x 4.88 cm)
Cover dimensions 6.99 x 6.77 x 0.975 in (W x H x D)
(17.75 x 17.20 x 2.48 cm)
Weight 1.0 lb (.45kg) (empty housing and cover)
Installing the wall/cover tamper
Regulatory information
Manufacturer UTC Fire & Security Americas Corporation, Inc.
1275 Red Fox Rd., Arden Hills, MN 55112-6943, USA
Certification
1. Push the wall/cover tamper switch into place as shown in
Figure 10 below.
2. Wire the tamper switch to the circuit board. (Refer to the
instructions for your board.)
3. Install the spring on the tamper switch.
Contact information
4. Install the wall tamper screw.
www.utcfireandsecurity.com or www.interlogix.com
Figure 10: Installation of the wall/cover tamper switch and
tinnerman nut
For customer support, see www.interlogix.com/customer-
support
Tamper Switch
Tinnerman Nut
Copyright © 2011 UTC Fire & Security Company. All rights
reserved.
Attaching the cover
1. Install the Tinnerman nut as shown in Figure 10 above.
2. Attach the cover over the housing with the screw hole
toward the bottom.
3. Install the cover screw through the Tinnerman nut (see
Figure 11 below).
4. If the housing is installed outside, use silicone caulk on the
edge of the cover to provide rain resistance
Figure 11: Bottom profile of housing
Cover Screw Hole
Multi-Purpose Housing Installation Instructions 3