usi CSL2700, Руководство пользователя

Страница: 10 / 34

10
Note: When loading your laminating film, check for film splices.
These rolls will be clearly marked. Splices are not common,
but are unavoidable. If you find a spliced roll, place it in the top
position on the laminator so that the splice can be monitored
carefully. When the splice is ready to come through the laminator,
turn the drive and heat off, allow the machine to cool, and rotate
the spliced roll of film by hand so the film tension is very loose.
Turn the drive switch on again and allow the splice to run through.
If necessary, keep turning the roll of film by hand to keep it slack
until the splice has passed through.
Caution: Do not apply excessive force to the ends of the
mandrel (i.e. with a hammer, etc.). Excessive force will
damage the mandrel. When loading the laminator, be sure the
heat is turned off and the machine is cool to avoid chance of
burns.
Note:
Film rolls must be centered on supply mandrels.
If the rolls are not aligned, hot adhesive will be deposited on the
heatshoes and rubber rollers, necessitating a cleaning operation.
Caution: When loading the laminator for the first time, be sure
that the heat is turned off and the machine is cool.
Photo 10 -1
Photo 10 -3
tHrEadInG dIaGram
Figure 10 -4
Photo 10 -2