usha MG 3563, Инструкция по эксплуатации

Страница: 8 / 12

OVERLOAD PROTECTION
Mixer is fitted with an over load protector off mechanism to avoid motor burning due to
overloading.
In case of excess loading of ingredients in the jar or very thick paste or low voltage conditions,
your USHA mixer grinder automatically switches off due to overloading and the red knob at
the bottom will come out. If this happens, switch off your mixer grinder and then remove the
excess ingredients / add sufficient water in case of thick paste and wait for 2-3 minutes. Press
red knob and start mixer again.
CLEANING AND MAINTENANCE
To keep your USHA Mixer Grinder sparkling clean, just follow these steps.
1. First remove the mains plug from the electrical socket.
2. Clean the main unit using a damp/wet cloth, but do not use any abrasive cleaning
materials.
3. Run the jar with water for a minute after each use to clean the residue.
4. Remove the jars after each use and wash the Jars in soapy water.
5. Then rinse with clean water
6. Dry the parts thoroughly with a clean, soft cloth.
7. Always keep/store the jar up side down.
8. We recommend you clean your USHA Mixer Grinder immediately after use for easier
removal of residue.
9. Do not immerse the base unit in water or any other liquid.
HOW TO CLEAN BLENDER / MIXER JAR
1. Empty the contents of the jar.
2. Place the jar assembly on the basic unit.
3. Fill about 500 ml of lukewarm water and add little mild detergent
(do not use abrasive cleaning powders since these will scratch the
jar) and put on cover and stopper. Switch on the motor and run it at
the lowest speed 1 for about 30 seconds.
4. Pour out the contents. Rinse with plain water. After cleaning keep
the jar up-side down while not in use.
5. Wipe the lower socket, rubber gaskets and the cutter assembly
using a wet cloth, then wipe with a dry cloth.
6. Finally, after disconnecting the unit from the mains, clean the body
with a damp cloth & polish with a dry cloth.