usha FH 3213-H, Инструкция по эксплуатации

Страница: 8 / 12

8
avoid it, it is necessary to clean the sprayer weekly and to change water as often
as possible. If you are not going to use the humidifying function for a long time:
- pour out water from the water tank and the sprayer, wash the water tank,
wash and clean the operating chamber of the sprayer and the sprayer itself,
dry thoroughly and take the unit away for storage.
Daily care
• Thoroughly wash the water tank (9) and the tray under the water tank (11)
once a week with a solvent with a neutral detergent. After it rinse them
thoroughly with water.
• Add 5-10 drops of purifying detergent on the sprayer; wait about 2-5 minutes.
Then remove the bloom from the surface of the sprayer.
Using the remote control
Open the lid of the battery compartment of theremote control and insert 2
batteries of “AAA” type, strictly following the polarity, close the battery
compartment lid.
• Press the on/off button (36), you will hear a sound signal, operation of the
unit in the fan mode indicator (29) will light up and the room temperature
indicator (21) will be displayed.
• Power is selected with the (35) button. Use low power for small rooms
heating, and max. power for large rooms heating.
• Set the necessary room temperature using the buttons (31) «+» «-».
• To switch on rotation press the (33) button, press the button (33) again to
switch off rotation.
• You can select the timer operation time using the (34) button on the remote
control or the (17) button on the control panel.
• Press the (32) button to switch on humidifying function.
• To switch on the fan heater press the (36) button on the remote control, set
the button (7) to the “0” position, and then take the plug out of the socket.
AuToMATIc sWITcHING oFF FuNcTIoN
The fan heater is equipped with auto switching off function when overheated.
• If the unit starts overheating, automatic thermal switch will be on, the fan
heater will switch off.
• In this case immediately take the plug out of the socket.
• Make sure that the rear and the front grids are unrestricted and nothing
prevents air flow.
• Let the fan heater to cool off for about 10-15 minutes before switching it on
again.