8
INSTALLATION (continued)
ELECTRICAL INSTALLATION
1. Refer to the nameplate. Verify the electrical
service power. Voltage and phase must
match the nameplate specifications.
Wiring the unit to the wrong voltage can
severely damage the unit or cause noticeably
decreased performance.
2. Available electrical service amperage must
meet or exceed the specifications listed on
the specification sheet provided with the unit.
a. Cord-connected units are equipped
with a three-prong (grounding) plug
for your protection against electric
shock. This must be plugged into a
properly grounded matching receptacle.
b. AFCP-5-7 and AFCP-6-7 field-wired
units connect to the pigtail leads in the
control box. Wiring must be secured to
the control box with an appropriate
strain relief (provided by installer).
The green ground wire must be
connected to a suitable building ground.
IMPORTANT:
*BLACK
wire = Power (HOT)
*WHITE
wire = Neutral
*GREEN
wire = Ground
3. Tank and control must be connected to an
appropriate building ground. Ground
connection will always be marked.
NOTE:
Field-wired units wire gauge, insulation type
and temperature rating, as well as type, size
and construction of conduit, must meet or
exceed applicable specifications of local
codes and of the National Electrical Code.
PLUMBING INSTALLATION
1. Plumb connections must be made in
Compliance with all Federal, State and
Local Plumbing Codes and Ordinances.
IMPORTANT
: All drain plumbing must be
performed by a qualified plumber.
2. Install provided 1” drain valve on unit drain.
Plumb to an appropriate waste as required by
local plumbing and sanitation ordinances.
WARNING:
Electric Shock Hazard
All servicing requiring access to
non-insulated electrical
components must be performed by
a factory-authorized technician.
DO NOT open any access panel
that requires the use of tools.
Failure to follow this warning can
result in severe electrical shock.
CAUTION:
Risk of Damage
DO NOT connect or energize this
appliance until all installation
instructions are read and followed.
Damage to the appliance will result
if these instructions are not
followed.
CAUTION
:
Electrical Shock Hazard
Cord-connected units are
equipped with a three-prong plug
for your protection against
electrical shock. Never cut the
large round prong from the plug,
or twist a blade to fit an existing
receptacle.
IMPORTANT:
Contact a licensed electrician
to install the correct circuit and
receptacle (cord-connected
units) or to install and connect
electrical power (field-wired
units).
IMPORTANT
