Page 35
TD-09-06-1064 LPV 100 SEED TREATER
ATOMIZER
To access the inside of the atomizer housing, disconnect the motor power cable from
the atomizer motor, push up on the quick release handle and slide out the atomizer.
After completing maintenance, slide the atomizer back into the operating position,
pull down quick release handle to lock it in place and reconnect the motor power cord.
Quick-Release
Handle
Atomizer Head
Set Screw
Bearing
1.
Slide out atomizer housing and grease
bearing inside. Bearing needs just one
pump of grease every 40 hours of
operation (right).
2.
Clean any build up inside the housing
and the atomizer head. To remove the
atomizer head, loosen the set screw
located on the bottom of the head.
3.
Check for any play in the atomizer shaft.
4.
Make sure the atomizer spins smoothly.
5.
Ensure the adjustable chute is fitting
completely into the drum opening.
Adjust if necessary.
REFER
TO
PAGE 5
