Select “After alert” in situations where the system transmits a voice message immediately
following the tones with no disruption in the continuous transmission of the carrier. If your
system uses this mode of operation, the N time delay should not be used.
Select “After call” in situations where the carrier drops following the transmission of tones
and then comes up again to send the voice message. This setting will eliminate recording
of tones when several sets of tones are transmitted prior to the message transmission.
Revert with N time delay is recommended in these cases.
If using the “After call” setting
for voice recording you need to make sure the carrier is ALWAYS interrupted prior to
sending the voice traffic else recording will not be initiated.
9. SCAN & OTHERS
The Scan option will only be available for pagers that have more than one frequency.
Staying time on F-2 for Priority Scan
This is the amount of time the pager will stay on F2 before it goes back to the priority
channel (F1).
