I
NDUSTRIES
, I
NC
.
I
NDUSTRIES
, I
NC
.
Since 1982
GripSafe Patents:
US – 9,927,058, 9,810,364 | CA – 3,004,787 | European Registration – 00626264-0001
Other US and Foreign Patents Pending
www.USAIndustries.com | (713) 941-3797
©2019, USA Industries, Inc.
FRM-23.1 Rev.B
9.1
Installing the lifting device on the GripSafe DBB 10” - 12” plug.
•
Remove the
MJIC-FNPT Adapter
①
from the
Vent Hose
②
. The internal thread for the lifting
device on 10”-12” plugs are located in the holes where the
Vent Hoses
②
originate.
•
Insert the
Vent Hose
②
into the hole of the
Lifting Standoff
㉓
(see
Figure 13
).
•
Insert the
Lifting Standoffs
㉓
into the two holes located on top of the
Spring Plate Hub
⑳
. Hand
tighten both
Lifting Standoffs
㉓
until they bottom out (see
Figure 13)
.
CAUTION:
A minimum of 6 full turns is needed when threading both the
Lifting Standoffs
㉓
into the
GripSafe DBB plug. Failure to follow this step may cause the
Lifting Threads
to fail under the load of
the plug, causing it to fall, injuring personnel and/or damage to the equipment.
9.2
Installing the lifting device on the GripSafe DBB 14+ plug.
•
On GripSafe DBB 14”+, the internal threads for the lifting device are located between the
Back
Pressure Vent Port
⑲
and
Vent Hose Ports
②
(see
Figure 14
).
•
Insert the
Lifting Standoffs
㉓
into the two holes through the
Spring Plate Hub
⑳
. Hand tighten
both
Lifting Standoffs
㉓
until they bottom out (see
Figure 14
).
CAUTION:
A minimum of 6 full turns is needed when threading both the
Lifting Standoffs
㉓
into the
GripSafe DBB plug. Failure to follow this step may cause the
Lifting Threads
to fail under the load of
the plug, causing it to fall, injuring personnel and/or damage to the equipment.
Page
21
of
24
Figure 13:
Inserting and Threading
Lifting
Standoffs
into the DBB 10” - 12” Plug
Figure 14:
Inserting and
Threading Lifting
Standoffs
in to the DBB Plug 14”+
