5.
INSTALLATION INSTRUCTIONS
1.
Remove the factory radio from the dash
2.
Disconnect existing CD Changer from the radio connectors if there is one
3.
Plug the CAS-CXi round DIN plug to the PA11-CHR interface box labeled
“RADIO”
4.
Connect the other end of the CAS-CXi to the factory radio CD Changer
connector, (Radios with “Mode” button use the square connector on the CAS-
CXi).
(Radios with “CD-C” button, remove rubber cover with the silver warning tape
and plug into radios 8-pin DIN connector.)
5.
Connect the audio output of the auxiliary device to AUX input jack on the
PA11-CHR if additional AUX option was selected by setting the DIP switch #1 to
“OFF”
6.
Set Dip switch #2 to “OFF” only if
Direct Mode
is preferred.
7.
Plug CB-PA14 cable to PA11-CHR adapter box labeled “iPod”
8.
Reinstall Radio
WARNING!!
Use only the iPod connection cable (part no. CB-PA14) included with the PA11-CHR interface. IPod
connection cables from other sources may look similar, but using them may damage your iPod
.
Revised October 9, 2009
iPod™ iPod™ Mini and iTune™ are trademarks of Apple Computers Inc. registered in the USA and other countries.
Chrysler is a registered trade mark of Daimler Chrysler Corporation.
Design and specifications are subject to change without notice.
© 1995-05 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark
holders.
