USB 7340
Dual Media Player with mixer
1. POWER SWITCH
Press the power switch to turn the unit on. To switch the POWER off press the POWER
switch again.
2. AC CORD
Use this cable to connect the AC main power to the unit.
3. GROUND TERMINAL CONNECTOR
Connect the GND terminal to the phono player ground.
4. FUSES
Under normal operation the fuses should not blow. A blown fuse usually indicates an
overload or fault condition. To change the fuse, remove the power cord, pry off the
fuse block with a small flathead screwdriver and change the blown fuses. Refer to
the specification for fuse current ratings.
5. INPUT
Plug in the line level device such as a phono player or additional CD player here.
6. LINE/PHONO INPUT TERMINAL SWITCH
Use this to allow either line level or phono level equipment to be plugged into your
channel inputs. when phono input is selected, your signal is fed directly to the high-
quality RIAA phono pre-amplifiers. Line level sources will overload the sensitive
phono pre-amps and will sound very bad, so always be sure to toggle the line/phono
switch over to line before connection of line sources.
7. STEREO MAIN OUTPUT
Unbalanced RCA connectors controlled by the master fader.
8. HEAD PHONE JACKS
To connect headphones.
9. CUE LEVEL CONTROL
Adjust CUE level output.
10. CUE CROSS FADER
Achieves clean seg uses between the two input Channels For head phones output,
Hard left selects channel 1, Hard right selects channel 2.
11. MICROPHONE BASS CONTROL
Adjusts microphone equalization of Bass
12. MICROPHONE TREBLE CONTROL
Adjusts microphone equalization of treble
13. MICROPHONE LEVEL
Adjusts microphone input level
