4. Check with a qualified electrician or service-
man if the grounding instructions are not com-
pletely understood, or if in doubt as to wheth-
er the tool is properly grounded.
5. Use only 3 wire extension cords that have
3-prong grounding plugs and 3-pole recep-
tacles that accept the tool’s plug.
6. Repair or replace damaged or worm core im-
mediately.
ASSEMBLY INSTRUCTIONS
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. COLLECTOR SUPPORT.
2. COLLECTOR BODY WITH MOTOR.
3. COLLECTOR.
4. BASE PLATE.
5. FOUR CASTERS.
6. TWO BAGS.
7. GASKET.
8. SCREWS AND WASHERS.
ASSEMBLY
Place the base plate
upside down and in-
stall the four casters
in holes provided and
tighten with the screw
driver as shown in fig-
ure 1.
Next, place the base
plate side up, attach
the collector support
to the base plate us-
ing the four holes
provided and tighten
with the open end
wrench as shown in
figure 2.
Place collector’s body to the motor plate on
the support and tighten the four bolts, washer,
and nuts with two open end wrench as shown
in figure 3 and 4.
Install the collector and packing to the fan/mo-
tor assy using six flange head screws, provided.
See figure 5 and figure 6.
The final steps to assemble your new dust col-
lector is to attach the collection bags by plac-
ing the bags over the opening and securing
with the belts that have been sewn into the
bags, as shown in figure 7.
10
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
1
6
2
3
4
5
8
7
Fig.1
RP542A manual.indd 10
01/07/15 11:48