20
DS1375-008E
Number of concurrent calls
Required bandwidth (upload & download)
1
85 kbps
2
174 kbps
4
358 kbps
8
696 kbps
7. CONNECTION TO THE NETWORK
Follow the procedure below to make network connections.
1. Connect one end of the Ethernet cable to the LAN port on the switch and the other end to the LAN
port (6) of the device.
It is possible to use a switch already arranged in the network or install a new one (see Ref.
1375/702) to make a new network. Do not use routers as switches, as they do not allow the
passage of VLAN between one network port and another.
2.
Connect the power supply to the mains. The power LED (1) will turn GREEN.
3.
The device will effectuate the software boot up procedure. At booting up, the status LED (2) of the
device will turn GREEN fixed to indicate that the system is working and ready to be configured. If you
do not have an Internet connection, the status LED (2) will blink alternatively BLUE and GREEN to
indicate the absence of communication with the Urmet Cloud. System configuration is still possible in
this condition.
In case the system cannot boot up correctly, refer to the table in the “
DESCRIPTION OF LEDS, CONNECTORS
AND BUTTONS” chapter.
Below is an example of the connection diagram.
WARNING!
the correct functioning and IT security of the IP networks on which Urmet products are installed
are entirely the responsibility of whoever manages the network infrastructure (consisting of switches,
routers, firewalls, etc.) and cannot be attributed to the products nor to Urmet. It is recommended that
you contact certified personnel specialized in computer network security to properly configure the network
infrastructure.