urmet domus ICARUS 4119, Инструкция по эксплуатации

Страница: 43 / 48

43
DS4119-001A
6.4 BASE SETTINGS
6.4.1 De-register a Handset
This operation should only be necessary if one of your handsets becomes faulty or lost and needs to
be replaced. You will need to enter the 4-digit System PIN (Default PIN is 0000) in order to de-register
a handset from the base station. A de-registered handset will have the antenna icon ashing and
“REGISTER” on the display.
You cannot de-register the handset that you are currently using.
1. Press <MENU> and <UP/DOWN> to select BS SETTINGS .
2. Press <OK> and <UP/DOWN> to select DELETE HS .
3. Press <OK> and the display shows “PIN?”.
4. Enter the 4-digit system PIN.
5. Press <OK> and the rst handset number is displayed.
6. Press <UP/DOWN> to scroll through the list of registered handsets and select the number of the
handset you want to de-register.
7. Press <OK> to con rm, and the chosen handset will be de-registered.
6.4.2 Change the dial mode
You should normally leave the dialling mode as its default setting of TONE (also called DTMF) unless
the phone is connected to an old exchange that only recognises PULSE dialling.
If PULSE dialling is set, you can press the * key to switch to TONE dialling for the rest of that call.
1. Press <MENU> and <UP/DOWN> to select BS SETTINGS .
2. Press <OK> and <UP/DOWN> to select DIAL MODE .
3. Press <OK> and <UP/DOWN> to select TONE or PULSE (the current setting is indicated by an
asterisk to the right).
4. Press <OK> to con rm.
6.4.3 Change the Flash (Recall) Time
You may need to change the recall ( ash) time if your phone is connected to a PABX. The recall time
options are SHORT (the default value of 100ms), MEDIUM (300ms) or LONG (600ms).
1. Press <MENU> and <UP/DOWN> to select
BS SETTINGS .
2. Press <OK> and <UP/DOWN> to select FLASH TIME .
3. Press <OK> and <UP/DOWN> to select your desired ash time (SHORT, MEDIUM, LONG, with the
current setting indicated by and asterisk to the right).
4. Press <OK> to con rm.
6.4.4 Change the System PIN Code
A 4-digit system PIN code is used for changing the system settings of the base station. It is used to
protect your phone against unauthorized use. The default system PIN code is 0000.
1. Press <MENU> and <UP/DOWN> to select
BS SETTINGS .
2. Press <OK> and <UP/DOWN> to select CHANGE PIN .
3. Press <OK> and you are requested to enter the 4-digit system PIN.
4. Enter the old system PIN.
5. Press <OK> and enter the new system PIN.
6. Press <OK> and enter the new system PIN again.
If the new PIN entered in Step 6 is not the same as the new system PIN entered in Step 5, you
must enter the new system PIN at step 5 again.
7. Press <OK> to con rm
†
†
†