VIDOORA Installation and Operating Instructions
Page | 8
3
3B
Mounting
The VIDOORA door station can be mounted on the
house wall in two ways. Select the mounting type
that suits you and follow the instructions in the
corresponding subchapter.
Wall mounting
The back of the enclosure is mounted directly to the wall.
Mounting on flush-mounted box
The back of the housing is placed on a standard flush-mounted
box with a diameter of 60 mm.
3.1
Wall mounting
Open housing
•
Loosen the two screws on the bottom of the
housing.
Keep the screws and the top part safe until you
need the parts again.
Figure 10: Bottom side of housing
•
Carefully unfold the underside (see the following
figure, point 1).
•
Carefully pull the upper part of the housing upwards
(see following figure).
Figure 11: Removing the upper part of the housing
8BP
lacement
and mounting on the wall
•
Select a location in the entrance area with an
unobstructed view of the desired camera image
section (see also illustrations of viewing angles).
I
MPORTANT
:
T
HE
wall surface should be flat.
•
Mounting 150 to 155cm from the floor. (lower edge
of VIDOORA door station).
Please adhere to this specification as far as possible
so that the camera's viewing angle is optimally
utilised.
•
Please mount the backside with the included dowels
and screws to the wall.
Figure 12: Fastening lower part
