4
DS1092-246A
INSTALLATION
1
Make sure that no units are powered before starting the installation procedure.
2
Install the camera on the bracket and fasten it.
3
Position the bracket to frame the required picture and fasten it to the wall or other flat surface.
4
Connect the video output to the utility.
5
Power the camera.
OPERATING FEATURES
TO SELECT THE REGULATIONS AND THE VIDEO OUTPUT
The 1092/256HZ camera may use 3 different video outputs, which are on the same BNC connector:
•
High-definition 1080P AHD (Analog High Definition) video output
•
CVBS standard interlaced video output
•
Video output in COMET mode
Press the central button IN THE CENTRE to access the OSD menu of the camera.
Press the button RIGHTWARDS OR LEFTWARDS to change the camera focus.
Press the button UPWARDS OR DOWNWARDS to change the camera zoom.
CVBS and AHD standards can be selected by holding the button pressed in the CENTRE. The control
alternatively selects the CVBS and AHD standards.
Use of the COMET video mode can be selected with the CVBS video signal by means of an option in the
OSD menu (ADJUST menu).
NOTE: COME option is available only with the CVBS video output.
The presence or absence of this option therefore permits to identify if the camera is using the CVBS or
AHD video output.
ENGLISH
MENU setting
UP
DOWN
RIGHT
LEFT
SET
